
beyerdynamic
beyerdynamic TG V70d
Dynamic (moving coil), hypercardioid, handheld live vocal mic with a shock-mounted capsule
Power None: a dynamic mic needs no power.
- Type
- Dynamic
- Pattern
- Hypercardioid
- Sensitivity
- −50 dBV/Pa
- Among 78 dynamics: more output than 95%
- Among 311 mics: more output than 34%
- Rated range
- 25 – 18k Hz
vs 25 handheld dynamics
More output than 92% of 25 handheld dynamics.
Each stripe is one handheld dynamic with a published sensitivity, and each bar counts them; further right means more output. This mic is in blue.
Proximity effect: the bass it gains up close
From the spec sheet, p. 2.
Titled "Frequency response ± 2.5 dB (at 1 m)", "0 dB = 3.2 mV/Pa"; "correspond to a typical production sample". Room and smoothing not stated.
Dashed: outside the rated range, or simulated (other angles and distances). Hover or tap the graphs for values.
Polar pattern
From the spec sheet, p. 2.
Untitled polar under "Frequency response & polar pattern" ("correspond to a typical production sample"); one full circle, 0° at the top, 5 dB rings to -20 dB. Measuring distance not stated.
In practice
All specs
| From the spec sheet | ||
|---|---|---|
| Sensitivity | −50 dBV/Pa (3.2 mV/Pa)open circuit, ±2.5 dB. "3.2 mV/Pa (-50 dBV) ±2.5 dB". The graph says "0 dB = 3.2 mV/Pa". | p. 1 |
| Output impedance | 280 ohmnominal | |
| Rated load impedance | 1000 ohmminimum ("≥ 1 kΩ") | |
| Rated frequency range | 25 Hz to 18 kHzclose miking; also [90, 16000], distant miking, measured at 1 m. "Close miking 25 - 18,000 Hz; Distant miking (measured at 1 m) 90 - 16,000 Hz". The manual's German column gives 90 - 18.000 Hz for the far field; the English and French say 16,000. | |
| Connector | XLR-3 male"3-pin XLR, male". | |
| Weight | 345 gwithout cable | |
| Dimensions | 54 × 185 mmHead diameter × length; "Shaft diameter 23/35 mm". | |
| Supplied accessories | MKV 8 microphone clamp (3/8" and 5/8"); storage bag"Supplied with microphone clamp and storage bag"; the manual names the MKV 8 (p. 1). | |
| Order number | 707.295 (TG V70d); 707.287 (TG V70d s, with locking on/off switch) | |
| Rear attenuation | > 25 dB at 110°, at 1 kHz | |
| Magnetic field suppression | > 20 dB at 50 Hz | |
| Capsule mount | Progressively damped capsule suspension for low handling noise | |
| Polarity | Positive pressure produces positive voltage on the brown lead (pin 2) | p. 2 |
| Optional accessories | BMC 05 FM and BMC 10 FM cables; GST 400, GST 500, ST 600 stands; MKV 8 clamp; WS 59 windshield (419.087) | p. 1 |
| From the manual | ||
| Version with switch | TG V70d s: the same with a locking on/off slide switch sunk into the shaft (locked "on" by turning a small screw 90°) | p. 1 |
| Pop screen | Integrated foam pop screen, removable for cleaning (unscrew the grille) | |
| Phantom power | "The use of phantom powering does not damage the microphone." | |
| Placementbeyerdynamic | Monitors aimed at the mic from the side and behind (about 110°); hold it slightly below the mouth; do not cup the grille | |
Documents
- TG V70d Dynamic Microphone, data sheetE3/TG V70d (08.13)
- TG V70d / TG V70d s Product InformationDE, EN, FR
- TG V70 - Dynamic Vocal Microphone | beyerdynamicproduct page
Copies kept by Mic Archive (manufacturers move and drop their documents). Each is © beyerdynamic, unchanged, with its original address.
Other mics
More from beyerdynamic
- beyerdynamic M 160
- beyerdynamic M 88 TG
- beyerdynamic M 130
- beyerdynamic M 201
- beyerdynamic M 260
- beyerdynamic MC 740
- beyerdynamic MC 834
- beyerdynamic MC 930