Mic Archive
Sennheiser e 965
Photo: Sennheiser, from its spec sheet, p. 1.

Sennheiser

Sennheiser e 965

Condenser (true condenser, 1" dual diaphragm), handheld vocal mic with switchable cardioid/supercardioid, low cut and -10 dB pad

Power Phantom 48 V.

Type
Condenser
Pattern
Switchable, 2CardioidSupercardioid
Sensitivity
−43.1 dBV/Pa
vs 14 handheld condensers

More output than 85% of 14 handheld condensers.

Each stripe is one handheld condenser with a published sensitivity, and each bar counts them; further right means more output. This mic is in blue.

  • Among 204 condensers: more output than 23%
  • Among 311 mics: more output than 46%
Self-noise
21 dB(A)
vs 12 handheld condensers

Quieter than 45% of 12 handheld condensers.

Each stripe is one handheld condenser with a published self-noise, and each bar counts them; further right means quieter. This mic is in blue.

  • Among 258 condensers: quieter than 19%
  • Among 272 mics: quieter than 19%
Max SPL
142 dB SPL
vs 14 handheld condensers

Takes louder sound than 38% of 14 handheld condensers.

Each stripe is one handheld condenser with a published max SPL, and each bar counts them; further right means it takes louder sound. This mic is in blue.

  • Among 277 condensers: takes louder sound than 73%
  • Among 343 mics: takes louder sound than 71%
Rated range
40 – 20k Hz
Released
2008

Frequency response

Angle

Distance

From the manual (Recording Hacks copy), p. 18.

Polar pattern

Transparency

From the manual (Recording Hacks copy), p. 18.

All specs

From the spec sheet
Capsule1" (25.4 mm) dual diaphragm, shock-mounted"Membran diameter 25.4 mm/1""; "Shock-mounted capsule".p. 1
Sensitivity−43.1 dBV/Pa (7 mV/Pa)free field, 1 kHz; also −52.8 dBV/Pa, with pre-attenuation (-10 dB), 2.3 mV/Pa. "7 mV/Pa", with pre-attenuation "2.3 mV/Pa"; converted (20 log10 0.007). The manual adds "no load".
Self-noise21 dB(A)"Equivalent noise level 21 dB (A)"; the manual says "A-weighted (DIN IEC 651)".
Max SPL142 dB SPLpassive (capsule and amplifier, no load stated); also 152 dB SPL, with pre-attenuation. "Maximum sound pressure level (passiv) 142 dB, with pre-attenuation 152 dB". The manual says "Max. SPL at 1 kHz"; no THD figure is given.
Output impedance50 ohmnominal, at 1 kHz. The manual says "approx. 50 Ω".
Rated load impedance1000 ohmminimum terminating impedance. "Min. terminating impedance 1 kΩ".
Rated frequency range40 Hz to 20 kHz"Frequency response 40 - 20,000 Hz"; no tolerance stated.
Poweringphantom 48 V"Phantom powering 48 V / 3.5 mA".
Current draw3.5 mA
Weight396 g
Dimensions48 × 199 mm"⌀ 48 x 199 mm": diameter by length.
Supplied accessoriesMZQ 800 microphone clamp; pouch"Delivery includes". Optional: MZW 4032-A (anthracite) and MZW 4032-C (blue) foam windshields.
Temperature range0 °C to +40 °C
Pop protectionHighly effective, integral acoustic pop and windshield; effective protection against moisture
From the manual (Recording Hacks copy)
Low cutoff, on"Switching the low-cut filter on/off" (bass roll-off switch); no frequency or slope stated.p. 12
Pad−10 dB"The sensitivity can be reduced by 10 dB"; switch positions "0" and "–10 dB".p. 11
ConnectorXLR-3Mp. 17
SwitchesDirectivity switch (cardioid/super-cardioid), sensitivity switch (0/–10 dB) and bass roll-off switch, under the sound inlet basketp. 7
Monitor placementSennheiserPlace monitors at the angle of highest cancellation: 180° in cardioid, 135° in super-cardioidp. 10
From the Recording Hacks page
Released2008

Documents

Copies kept by Mic Archive (manufacturers move and drop their documents). Each is © Sennheiser, unchanged, with its original address.

Other mics

More from Sennheiser

All 40 Sennheiser mics

Other cardioid / supercardioid condenser mics

All 419 mics