Mic Archive
Audio-Technica AT4022
Photo: Audio-Technica, from its spec sheet, p. 1.

Audio-Technica

Audio-Technica AT4022

Small-diaphragm condenser (fixed-charge back plate), omnidirectional, end-address, with 80 Hz high-pass and 10 dB pad switches

Power Phantom 48 V DC.

Type
Condenser (electret)
Pattern
Omnidirectional
Sensitivity
−34 dBV/Pa
vs 75 end-address condensers

More output than 66% of 75 end-address condensers.

Each stripe is one end-address condenser with a published sensitivity, and each bar counts them; further right means more output. This mic is in blue.

  • Among 204 condensers: more output than 69%
  • Among 311 mics: more output than 79%
Self-noise
13 dB(A)
vs 104 end-address condensers

Quieter than 79% of 104 end-address condensers.

Each stripe is one end-address condenser with a published self-noise, and each bar counts them; further right means quieter. This mic is in blue.

  • Among 258 condensers: quieter than 67%
  • Among 272 mics: quieter than 68%
Max SPL
146 dB SPL
vs 110 end-address condensers

Takes louder sound than 91% of 110 end-address condensers.

Each stripe is one end-address condenser with a published max SPL, and each bar counts them; further right means it takes louder sound. This mic is in blue.

  • Among 277 condensers: takes louder sound than 84%
  • Among 343 mics: takes louder sound than 82%
Rated range
20 – 20k Hz

Frequency response

Angle

Distance

From the spec sheet, p. 2.

Polar pattern

Transparency

From the spec sheet, p. 2.

All specs

From the spec sheet
Sensitivity−34 dBV/Pa (19.9 mV/Pa)open circuit. "–34 dB (19.9 mV) re 1V at 1 Pa".p. 2
Self-noise13 dB(A)typical, A-weighted (Audio Precision System One). "13 dB SPL", footnote "Typical, A-weighted, using Audio Precision System One".
Max SPL146 dB SPL1 kHz, 1% THD; also 156 dB SPL, with 10 dB pad (nominal); also 148 dB SPL, 1 kHz, 1% THD (Japanese manual, 2009). The 2008 sheet gives the same 146/156 dB.
Signal-to-noise ratio81 dB1 kHz at 1 Pa; typical, A-weighted; also 78 dB, 1 kHz at 1 Pa, "78 dB or more" (Japanese manual, 2009)
Dynamic range133 dB1 kHz at max SPL, typical
Output impedance250 ohm
Rated frequency range20 Hz to 20 kHzTolerance not stated.
Poweringphantom 48 V DC"48V DC, 3.0 mA typical"; the Japanese manual says "ファントム11~52VDC" (phantom 11-52 V DC).
Current draw3 mAtypical
Low cutflat, roll-off; 80 Hz; 18 dB/octave; high-pass"80 Hz, 18 dB/octave"; switches "Flat, roll-off; 10 dB pad (nominal)". The 2008 sheet and the Japanese manual say 12 dB/octave.
Pad−10 dB"10 dB pad (nominal)".
ConnectorXLR-3 male (integral)"Integral 3-pin XLRM-type".
Weight124 g"124 g (4.4 oz)".
Dimensions21 × 144 mmDiameter × length: "144.0 mm (5.67") long, 21.0 mm (0.83") diameter".
Supplied accessoriesAT8405a stand clamp for 5/8"-27 threaded stands; AT8159 windscreen; protective carrying case
OutputLow impedance balanced, pin 2 hotp. 1
Case styleS1p. 2
Operating temperatureAvoid more than 43 °C (110 °F) for long periods, and very high humidityp. 1
From the manual
Capsule19.2 mm "Double Wave Diaphragm""新開発φ19.2大口径ダイアフラム" and "ダブル・ウェーブ・ダイアフラム(PAT.P.)" (newly developed 19.2 mm diameter diaphragm; Double Wave Diaphragm, patent pending).p. 1
RF immunityImproved protection against interference from mobile phones and wireless intercoms
Made inJapan

Documents

Copies kept by Mic Archive (manufacturers move and drop their documents), unchanged, with their original addresses. Each is © its publisher.

Other mics

More from Audio-Technica

All 32 Audio-Technica mics

All 419 mics