Mic Archive
Earthworks M30
Photo: Earthworks, from its user guide, p. 1.

Earthworks Audio

Earthworks M30

Omnidirectional measurement condenser mic, 3 Hz to 30 kHz, Type 1; for room and PA measurement

Power Phantom 24-48 V.

Type
Condenser
Pattern
Omni
Sensitivity
−29 dBV/Pa
vs 75 end-address condensers

More output than 92% of 75 end-address condensers.

Each stripe is one end-address condenser with a published sensitivity, and each bar counts them; further right means more output. This mic is in blue.

  • Among 204 condensers: more output than 95%
  • Among 311 mics: more output than 96%
Self-noise
20 dB(A)
vs 104 end-address condensers

Quieter than 19% of 104 end-address condensers.

Each stripe is one end-address condenser with a published self-noise, and each bar counts them; further right means quieter. This mic is in blue.

  • Among 258 condensers: quieter than 23%
  • Among 272 mics: quieter than 23%
Max SPL
140 dB SPL
vs 110 end-address condensers

Takes louder sound than 64% of 110 end-address condensers.

Each stripe is one end-address condenser with a published max SPL, and each bar counts them; further right means it takes louder sound. This mic is in blue.

  • Among 277 condensers: takes louder sound than 62%
  • Among 343 mics: takes louder sound than 56%
Rated range
3 – 30k Hz

Frequency response

Angle

Distance

From the graph response, p. 1.

Polar pattern

Transparency

From the graph polar, p. 1.

All specs

From the spec sheet
Max SPL140 dB SPL"Max Acoustic Input 140dB SPL".p. 2
Rated load impedance600 ohmminimum, between pins 2 and 3. "Min Output Load 600Ω between pins 2 & 3".
Rated frequency range3 Hz to 30 kHz+1/-3 dB. "3Hz to 30kHz ± 1/-3dB"; the product page and user guide give "3Hz to 30kHz" alone.
Poweringphantom 24-48 V"24-48V Phantom, 10mA".
Current draw10 mA
ConnectorXLR-3 male (pin 2 hot)"XLR-3 (pin 2+)".
Weight227 galso 225, product page and user guide. "0.5 lb. (227g)"; the product page and user guide say ".5 lb. (225g)".
Dimensions229 × 22 mmLength x diameter: "9 x .860 in. (229 x 22 mm)".
StandardsMeets or exceeds Type 1 and applicable IEC 61094 requirements
Operating temperature-20 to +60 °C (-4 to 140 °F)
Storage temperature-40 to +80 °C (-40 to 176 °F)
HumidityUp to 90%
MatchingAny number of mics can be matched for a nominal feep. 1
ApplicationsEarthworksSMAART, MLSSA, Spectrafoo, TEF, RTA and all "audio band" measurements; PA alignment and loudspeaker designp. 2
From the product page
Sensitivity−29 dBV/Pa (34 mV/Pa)typical. "34mV/Pa (-29dBV/Pa)" (20·log10(0.034) = -29.4).p. 1
Self-noise20 dB(A)"20dB SPL equivalent (A weighted)"; the data sheet gives "20dB SPL" without a weighting.
Output impedance65 ohmbalanced, between pins 2 and 3. "65Ω balanced (between pins 2 & 3)".
From the user guide
Supplied accessoriesmicrophone clip; calibration adapter; calibration chart"Your purchase includes": the M30, a microphone clip, a calibration adapter, a calibration chart, and a frequency response data sheet available on registering.p. 2
CalibrationCalibrated at the factory at 1 kHz; re-calibration recommended every five years; each mic comes with its own printed response chart and a downloadable Electronic Calibration Filep. 3

Documents

Copies kept by Mic Archive (manufacturers move and drop their documents), unchanged, with their original addresses. Each is © its publisher.

Other mics

More from Earthworks

Other omni condenser mics

All 419 mics