
Earthworks Audio
Earthworks TC20
Omnidirectional (pressure) prepolarized condenser for loud sources, small-diameter tip on a tapered steel body
Power Phantom, 24-48 V.
- Type
- Condenser (electret)
- Pattern
- Omni
- Sensitivity
- −41.9 dBV/Pa computed
- Self-noise
- 26 dB(A)
- Among 258 condensers: quieter than 8%
- Among 272 mics: quieter than 8%
- Max SPL
- 150 dB SPL
- Among 277 condensers: takes louder sound than 92%
- Among 343 mics: takes louder sound than 91%
- Rated range
- 9 – 20k Hz
- Released
- 2000
vs 104 end-address condensers
Quieter than 4% of 104 end-address condensers.
Each stripe is one end-address condenser with a published self-noise, and each bar counts them; further right means quieter. This mic is in blue.
vs 110 end-address condensers
Takes louder sound than 97% of 110 end-address condensers.
Each stripe is one end-address condenser with a published max SPL, and each bar counts them; further right means it takes louder sound. This mic is in blue.
Proximity effect: the bass it gains up close
From the manual (Recording Hacks copy), p. 2.
Fig. 2 "Frequency Response (Typical) of TC20" in the 2005 owner's manual; relative dB, 3 dB per division. A smooth "typical" curve; the text calls the response "free-field". Distance and room not stated.
Dashed: outside the rated range, or simulated (other angles and distances). Hover or tap the graphs for values.
In practice
All specs
| From the user guide | ||
|---|---|---|
| Sensitivity | −41.9 dBV/Pa (8 mV/Pa)typical. Not stated by the manufacturer: Converted from "8mV/Pa (Typical)" (20 log10 0.008); the 2005 manual gives the same 8 mV/Pa. | p. 4 |
| Self-noise | 26 dB(A)equivalent, A-weighted; also 27 dB(A), 2005 manual: "27dBA equivalent". "26dB SPL (A weighted)". | |
| Max SPL | 150 dB SPLpeak acoustic input; also 145 dB SPL, 2005 manual. "Peak Acoustic Input: 150dB SPL"; the 2005 manual says 145dB SPL. | |
| Output impedance | 65 ohmbalanced between pins 2 and 3; also 100 ohm, 2005 manual: "100Ω, balanced (50Ω ea. pin 2 & 3)" | |
| Rated load impedance | 600 ohmminimum, balanced between pins 2 and 3. The 2005 manual agrees. | |
| Rated frequency range | 9 Hz to 20 kHz+1/-3 dB; also [10, 20000], ±2 dB (2005 manual). "9Hz to 20kHz +1/-3dB". | |
| Powering | phantom, 24-48 V"24-48V Phantom, 10mA"; the 2005 manual says "48V Phantom, 10mA". | |
| Current draw | 10 mA | |
| Connector | XLR-3 male"Output: XLR-3". | |
| Weight | 160 g"160g (.31b)"; the 2005 manual says "160g (.35lb)", which matches 160 g. | |
| Dimensions | 165 × 22 mmLength × diameter ("165 x 22 mm (6.5 x .860 in.)"). | |
| Supplied accessories | Microphone clip"YOUR PURCHASE INCLUDES: 1 Earthworks TC20, 1 Microphone Clip". | p. 2 |
| From the manual (Recording Hacks copy) | ||
| ApplicationsEarthworks | Close-miking louder sources: instrument amps, drums, close-miked brass; under the strings of a double bass, inside a kick drum; drum overheads; a pair for recording rehearsals and performances | p. 2 |
| Free-field response | "A linear free-field frequency response from 10Hz to 20kHz"; no proximity effect, very low handling noise | |
| Settling time | Allow up to one minute after phantom power is applied; plugging in "hot" is preferred for faster settling | |
| Construction | No removable parts; cannot be opened | |
| Calibration | A calibration chart is enclosed (warranty details on its back) | p. 1 |
| Origin | Made in U.S.A. | |
| From the Recording Hacks page | ||
| Released | 2000 | |
Documents
- TC20 Omnidirectional Microphone for Loud Sourcesuser guide, May 2022
- TC20 Omnidirectional Microphone Owner's Manual2005
- Earthworks Audio TC20 | RecordingHacks.com
Copies kept by Mic Archive (manufacturers move and drop their documents), unchanged, with their original addresses. Each is © its publisher.
Recommended for
By recording guides, engineers and mic makers, for this mic or an earlier version of it.