Mic Archive

Behringer

Behringer C-2

Small-diaphragm cardioid condenser, sold as a matched pair

Power Phantom, +48 V.

Type
Condenser
Pattern
Cardioid
Sensitivity
−41 dBV/Pa
vs 75 end-address condensers

More output than 15% of 75 end-address condensers.

Each stripe is one end-address condenser with a published sensitivity, and each bar counts them; further right means more output. This mic is in blue.

  • Among 204 condensers: more output than 29%
  • Among 311 mics: more output than 50%
Self-noise
19 dB(A)
vs 104 end-address condensers

Quieter than 27% of 104 end-address condensers.

Each stripe is one end-address condenser with a published self-noise, and each bar counts them; further right means quieter. This mic is in blue.

  • Among 258 condensers: quieter than 29%
  • Among 272 mics: quieter than 28%
Max SPL
140 dB SPL
vs 110 end-address condensers

Takes louder sound than 64% of 110 end-address condensers.

Each stripe is one end-address condenser with a published max SPL, and each bar counts them; further right means it takes louder sound. This mic is in blue.

  • Among 277 condensers: takes louder sound than 62%
  • Among 343 mics: takes louder sound than 56%
Rated range
20 – 20k Hz
Released
2008

Frequency response

Angle

Distance

From the manual (Recording Hacks copy), p. 5.

Polar pattern

Transparency

From the manual (Recording Hacks copy), p. 5.

All specs

From the manual (Recording Hacks copy)
Capsule16 mmp. 4
Sensitivity−41 dBV/Paopen circuit, 1 kHz. Printed "−41 dBV (0 dBV = 1 V/Pa)".
Self-noise19 dB(A)equivalent noise level, IEC 651
Max SPL140 dB SPL≤ 1% THD at 1 kHz, pad off; also 150 dB SPL, with the -10 dB pad
Signal-to-noise ratio75 dBReference level and weighting not stated.
Output impedance75 ohmnominal
Rated load impedance1000 ohmmore than. "Load impedance > 1 kΩ".
Rated frequency range20 Hz to 20 kHzTolerance not stated. The printed graph starts at 50 Hz.
Poweringphantom, +48 V"Supply voltage +48 V"; page 2: "Phantom power (+48 V) is required".
Current draw3 mAp. 5
Low cutoff, on; 120 Hz; 6 dB/octave"6 dB/oct. @ 120 Hz (switchable)". Page 3: one three-position switch; the middle position is the low cut.p. 4
Pad−10 dB"−10 dB, switchable": the switch's "−10 dB" position (page 3).
Switchesfilter and pad: flat, low cut, -10 dB"When the switch is in its top-most position, the signal is not influenced"; middle: low cut; "−10 dB": the pad. So the low cut and the pad can't be used together.p. 3
ConnectorXLR-3 male"gold-plated balanced XLR connector"; pin 1 shield, pin 2 +, pin 3 - (page 4).p. 4
Weight90 g"approx. 0.2 lbs (approx. 0.09 kg)".p. 5
Dimensions94 × 20 mmLength × shaft diameter.
Supplied accessoriesTwo stand clamps; Protective case; Windscreen; Moisture-absorbing crystalsClamps: page 4 ("two clamps are included"). Case, windscreen and crystals: page 2.p. 2
Operating principlepressure gradientp. 4
PairSold as two microphones, matched to one another (matched pair), for stereo recordingp. 2
WiringBalanced XLR cable: pin 1 = shielding; pin 2 = +; pin 3 = -p. 4
From the Recording Hacks page
Released2008

Documents

Copies kept by Mic Archive (manufacturers move and drop their documents). Each is © Behringer, unchanged, with its original address.

Other mics

More from Behringer

Other cardioid condenser mics

All 419 mics