Mic Archive

DPA

DPA 4011A

Small-diaphragm condenser, cardioid (19 mm pencil); the upgraded classic 4011

Approximate Some readings for this mic are uncertain; see the graphs.

Power Phantom 48 V ± 4 V.

Type
Condenser (electret)
Pattern
Cardioid
Sensitivity
−40 dBV/Pa
vs 75 end-address condensers

More output than 20% of 75 end-address condensers.

Each stripe is one end-address condenser with a published sensitivity, and each bar counts them; further right means more output. This mic is in blue.

  • Among 204 condensers: more output than 33%
  • Among 311 mics: more output than 53%
Self-noise
18 dB(A)
vs 104 end-address condensers

Quieter than 34% of 104 end-address condensers.

Each stripe is one end-address condenser with a published self-noise, and each bar counts them; further right means quieter. This mic is in blue.

  • Among 258 condensers: quieter than 33%
  • Among 272 mics: quieter than 32%
Max SPL
139 dB SPL
vs 110 end-address condensers

Takes louder sound than 59% of 110 end-address condensers.

Each stripe is one end-address condenser with a published max SPL, and each bar counts them; further right means it takes louder sound. This mic is in blue.

  • Among 277 condensers: takes louder sound than 58%
  • Among 343 mics: takes louder sound than 53%
Rated range
20 – 20k Hz

Frequency response

Instruments sources recommend it for most

5 of 28; all under Recommended for.

Angle

Distance

From the spec sheet, p. 2.

Polar pattern

Transparency

From the spec sheet, p. 2. Approximate

All specs

From the spec sheet
Capsulepre-polarized condenser, pressure gradient, 19 mmp. 2
Sensitivity−40 dBV/Pa (10 mV/Pa)1 kHz, nominal ±2 dB. "10 mV/Pa; -40 dB re. 1 V/Pa".
Self-noise18 dB(A)typical; max. 20 dB(A)
Self-noiseCCIR 46825 dBITU-R BS.468-4, typical, either pad setting
Max SPL139 dB SPLpeak, THD < 1%; also 159 dB SPL, peak, before clipping
Signal-to-noise ratio76 dBA-weighted, re 94 dB SPL, typical
Dynamic range121 dBtypical
Output impedance200 ohmless than
Rated load impedance2000 ohmminimum
Rated frequency range20 Hz to 20 kHz40 Hz to 20 kHz within ±2 dB.
Poweringphantom 48 V ± 4 V
Current draw2.8 mA
Pad−20 dBSwitchable 0 / -20 dB, a switch in the centre of the XLR connector (p. 1).
ConnectorXLR-3 male
Weight158 g
Dimensions19 × 170 mmDiameter × length; capsule diameter 19 mm.
Finishmatte black
OutputImpedance balanced with Active Drive; drives 100 m of cable; > 5 V RMS output; CMRR > 60 dB
Temperature and humidity-40 to 45 °C; up to 90% RH
Stereo pairST4011A, matched within ±1 dB and < 10° phasep. 1

Documents

Copies kept by Mic Archive (manufacturers move and drop their documents). Each is © DPA, unchanged, with its original address.

Other mics

More from DPA

All 19 DPA mics

Other cardioid condenser mics

All 419 mics