Mic Archive
Electro-Voice N/D468
Photo: Electro-Voice, from its spec sheet (Recording Hacks copy), p. 1.

Electro-Voice

Electro-Voice N/D468

Dynamic (N/DYM neodymium), supercardioid, instrument mic with pivoting yoke

Power None: a dynamic mic needs no power. Low output: it needs a lot of preamp gain.

Type
Dynamic
Pattern
Supercardioid
Sensitivity
−50.2 dBV/Pa computed
Self-noise
14 dB(A)
vs 272 mics

Quieter than 60% of 272 mics.

Each stripe is one mic with a published self-noise, and each bar counts them; further right means quieter. This mic is in blue.

Rated range
30 – 22k Hz
Released
1999

Frequency response

Angle

Distance

From the spec sheet, p. 3.

Polar pattern

Transparency

From the spec sheet, p. 3.

All specs

From the spec sheet
CapsuleNeodymium-iron-boron (N/DYM) magnet, large reinforced diaphragm, hum-bucking coil, AcoustiDYM shock mountp. 1: "neodymium-iron-boron magnetic structure", "a large, reinforced diaphragm", "a highly effective hum-bucking coil", "AcoustiDYM™ shock-mount system".p. 1
Sensitivity−50.2 dBV/Pa (3.1 mV/Pa)open circuit, 1 kHz. Not stated by the manufacturer: Converted from "3.1 mV/pascal" (20·log10(0.0031) = -50.2); the 2003 sheet agrees.p. 4
Self-noise14 dB(A)equivalent output noise. "Equivalent Output Noise: 14 dB A weighted (0 dB= 0.00002 pascal)"; the 2003 sheet agrees.
Dynamic range144 dB"Dynamic Range: 144 dB".
Output impedance150 ohmbalanced (low-Z); also 350 ohm, 2003 Telex sheet. "150 ohms balanced (low–Z)". The 2003 sheet says "350 ohms balanced (low-z)".
Rated frequency range30 Hz to 22 kHzclose response; also [60, 22000], far response. "Frequency Response, Close Response: 30-22,000 Hz; Far Response: 60-22,000 Hz". No tolerance stated.
Weight190 gnet. "Net Weight: 190 g (6.7 oz)"; shipping weight 453 g.
Dimensions115 × 52 mm"Length: 115 mm (4.5 in.)", "Diameter: 52 mm (2.05 in.)": length, head diameter. Shank 20 mm (0.80 in.).
FinishNon-reflecting black; Memraflex grille screen"Finish: Nonreflecting black"; "Grill Screen: Memraflex™".
Supplied accessories311 stand clamp; soft zippered gig bagThe 2003 sheet calls the clamp "311 Stand Adapter".
Power level-51 dB at 1 kHz (0 dB = 1 mW/pascal)
PolarityPositive pressure on the diaphragm gives positive voltage on pin 2 with respect to pin 3
Shank20 mm (0.80 in.)
MountingExclusive pivoting yokep. 1
Pop filterAcoustifoam filter built into the removable front grille
Proximity effectMaximum bass with the mic 1/4 inch (about 6 mm) from the source; minimal (normal) bass beyond 24 inches (about 60 cm)
Certificate of PerformanceEach mic's measured response is plotted on a certificate shipped with it; it may differ from the published average responsep. 2
Part numbers534570-9805 (1998 sheet); N/D468 part number 16043008 (2003)p. 4
From the spec sheet (Recording Hacks copy)
ConnectorXLR-3"Microphone Connector: 3-pin, XLR-type".p. 1
Voice coilLarge diameter, "up to 50% larger than other mics"
PlacementElectro-VoiceGuitar or bass amp: 1-2 in. from the cone, at 90°; toms: 1-3 in. over the head at 45°, 1-2 in. in from the rim; snare: 1-3 in. above, 1-2 in. in from the rim; hi-hat: 5 in. above the outside edge, 45° down; brass: 6-24 in. on the bell axis; acoustic guitar: 6-12 in. from where the fingerboard joins the bodyp. 2
From the Recording Hacks page
Released1999

Documents

Copies kept by Mic Archive (manufacturers move and drop their documents). Each is © Electro-Voice, unchanged, with its original address.

Other mics

More from Electro-Voice

All 23 Electro-Voice mics

Other supercardioid dynamic mics

All 419 mics