Mic Archive
AKG C 1000 S
Photo: AKG, from its catalog (Recording Hacks copy), p. 1.

AKG

AKG C 1000 S

End-address small-diaphragm electret condenser, cardioid or hypercardioid (with the PPC 1000 converter), powered by phantom or an internal 9 V battery

Approximate Some readings for this mic are uncertain; see the graphs.

Power Phantom 9 to 52 V (IEC 61938) or internal 9 V battery.

Type
Condenser (electret)
Pattern
Switchable, 2CardioidHypercardioid
Sensitivity
−44 dBV/Pa
vs 75 end-address condensers

More output than 11% of 75 end-address condensers.

Each stripe is one end-address condenser with a published sensitivity, and each bar counts them; further right means more output. This mic is in blue.

  • Among 204 condensers: more output than 20%
  • Among 311 mics: more output than 44%
Self-noise
21 dB(A)
vs 104 end-address condensers

Quieter than 15% of 104 end-address condensers.

Each stripe is one end-address condenser with a published self-noise, and each bar counts them; further right means quieter. This mic is in blue.

  • Among 258 condensers: quieter than 19%
  • Among 272 mics: quieter than 19%
Max SPL
137 dB SPL
vs 110 end-address condensers

Takes louder sound than 51% of 110 end-address condensers.

Each stripe is one end-address condenser with a published max SPL, and each bar counts them; further right means it takes louder sound. This mic is in blue.

  • Among 277 condensers: takes louder sound than 50%
  • Among 343 mics: takes louder sound than 46%
Rated range
50 – 20k Hz

Frequency response

Instruments sources recommend it for most
Angle

Distance

From the catalog (Recording Hacks copy), p. 2.

Polar pattern

Transparency

From the manual (Recording Hacks copy), p. 25. Approximate

All specs

From the manual (Recording Hacks copy)
Sensitivity−44 dBV/Pa (6 mV/Pa)"6 mV/Pa (-44 dBV)".p. 25
Self-noise21 dB(A)also 32 dB(A), CCIR 468-3. The 2001 application note gives 19 dB(A).
Max SPL137 dB SPL1% THD. "Max. SPL for 1% THD: 137 dB". The 2001 application note gives 137 dB for 0.5% THD.
Signal-to-noise ratio73 dBA-weighted
Output impedance200 ohm
Rated load impedance2000 ohmminimum, recommended. "≥2000 ohms".
Rated frequency range50 Hz to 20 kHz
Poweringphantom 9 to 52 V (IEC 61938) or internal 9 V batteryThe leaflet: "9-52 V phantom power in accordance with DIN 45596 or internal 9 V battery (6F 22)". It switches to phantom power by itself when phantom is present (p. 17).
Current draw2 mAapprox.
ConnectorXLR-3 male (pin 2 hot)Pin 1 ground, pin 2 audio (in phase), pin 3 audio (p. 17).
Weight320 gnet. Shipping weight 650 g.
Dimensions34 × 220 mmDiameter × length.
PB 1000 presence boost adapterRaises the sensitivity by about 5 dB between 5 and 9 kHzp. 16
BATT CHECK LEDFlashes briefly at switch-on with a good battery; stays lit when about 60 minutes of battery life are left; dark on phantom power
On/off switchRecessed, to save the battery
BodySolid aluminium shaft, screw-on brass front tube, stainless steel mesh cap; capsule in an elastic mount
FinishMatte silver enamelp. 25
From the catalog (Recording Hacks copy)
Supplied accessoriesW 1000 windscreen; SA 63 stand adapter; PPC 1000 polar pattern converter; PB 1000 presence boost adapter; bag"Standard accessories: W 1000, SA 63, PPC 1000, PB 1000, microphone bag". The manual's packing list shows an H 63 and a carrying case (p. 15).p. 2
Optional accessoriesB 18, MK 9/10, PF 80
Item number2331 Z 0007
PatentsAT 385.386 / US 4.790.021; AT 392.182 / DE 4.021.661
From the service rh
CapsuleCE33 back-electret capsule in an elastic suspensionp. 2
From the spec sheet (Recording Hacks copy)
SuccessorThe 2012 C1000 S (MkIV) runs on two AA batteries and adds a 0/-10 dB pad and an 80 Hz bass cutp. 2

Documents

Copies kept by Mic Archive (manufacturers move and drop their documents), unchanged, with their original addresses. Each is © its publisher.

Other mics

More from AKG

All 24 AKG mics

All 419 mics