
Audio-Technica
Audio-Technica PRO 45
Miniature cardioid condenser hanging mic for choirs, ensembles and stages, on a 7.6 m attached cable with the electronics in the XLR plug
Power Phantom 9-52 V DC.
- Type
- Condenser (electret)
- Pattern
- Cardioid
- Sensitivity
- −37 dBV/Pa
- Among 204 condensers: more output than 51%
- Among 311 mics: more output than 66%
- Self-noise
- 28 dB(A) computed
- Max SPL
- 134 dB SPL
- Among 277 condensers: takes louder sound than 33%
- Among 343 mics: takes louder sound than 30%
- Rated range
- 70 – 16k Hz
vs 75 end-address condensers
More output than 49% of 75 end-address condensers.
Each stripe is one end-address condenser with a published sensitivity, and each bar counts them; further right means more output. This mic is in blue.
vs 110 end-address condensers
Takes louder sound than 27% of 110 end-address condensers.
Each stripe is one end-address condenser with a published max SPL, and each bar counts them; further right means it takes louder sound. This mic is in blue.
Proximity effect: the bass it gains up close
From the spec sheet, p. 1.
"Frequency Response", "12" or more on axis" (about 30 cm). No dB labels: scaled from the "10 dB" bar and set to 0 dB at 1 kHz. Room and smoothing not stated.
Dashed: outside the rated range, or simulated (other angles and distances). Hover or tap the graphs for values.
Polar pattern
From the spec sheet, p. 2.
"Polar Pattern", full circle, 0° up; "SCALE IS 5 DECIBELS PER DIVISION". Measuring conditions not stated.
In practice
All specs
| From the spec sheet | ||
|---|---|---|
| Sensitivity | −37 dBV/Pa (14.1 mV/Pa)open circuit, 1 kHz. "–37 dB (14.1 mV) re 1V at 1 Pa". | p. 2 |
| Self-noise | 28 dB(A)Not stated; 94 dB SPL minus the 66 dB signal-to-noise ratio. | |
| Max SPL | 134 dB SPL1 kHz, 1% THD. "134 dB SPL, 1 kHz at 1% T.H.D." | |
| Signal-to-noise ratio | 66 dB1 kHz at 1 Pa, A-weighted, typical. "66 dB, 1 kHz at 1 Pa"; footnote "Typical, A-weighted, using Audio Precision System One". | |
| Dynamic range | 106 dB1 kHz at max SPL, typical | |
| Output impedance | 100 ohm"100 ohms"; page 1: "Output is low impedance balanced". | |
| Rated frequency range | 70 Hz to 16 kHz | |
| Powering | phantom 9-52 V DC"9-52V DC, 2 mA typical". | |
| Current draw | 2 mAtypical | |
| Connector | XLR-3 male at the end of the attached cable"3-pin XLRM-type"; the dimension drawing shows the XLR housing as 68.0 mm long, 19.0 mm diameter. | |
| Weight | 15 gless cable. "0.5 oz (15 grams)". | |
| Dimensions | 56.9 × 12 mmLength × head diameter: "2.24" (56.9 mm) long, 0.47" (12.0 mm) head diameter". | |
| Finish | low-reflectance black (PRO 45); white (PRO 45W) | p. 1 |
| Supplied accessories | foam windscreen (AT8146); steel hanger"Foam windscreen, steel hanger"; page 1 names the windscreen AT8146. | p. 2 |
| Models | PRO 45: black. PRO 45W: white mic housing, windscreen, cable and steel hanger, for hanging against a light background | p. 1 |
| Cable | 7.6 m (25 ft), permanently attached, 2.6 mm diameter, 2-conductor shielded | p. 2 |
| Hanger | Vinyl-coated steel wire hanger; twist the mic in the hanger to aim it | p. 1 |
| PlacementAudio-Technica | Hang forward of the front-most source, above the rear-most, aimed between them; the distance to the rear-most source no more than twice that to the front. Pickup width is about three times the distance to the nearest performer; space extra mics at least three times the distance to the front source | |
| Optional accessories | AT8104a large metal windscreen; AT8117 large foam windscreen; CP8201 line matching transformer; AT8202 in-line attenuator; AT8314 cable; CP8506 and AT8801 phantom power supplies | p. 2 |
Documents
- PRO 45 and PRO 45W Remote-Powered Cardioid Condenser Hanging MicrophonesForm No. 0320-0805-02
Copies kept by Mic Archive (manufacturers move and drop their documents). Each is © Audio-Technica, unchanged, with its original address.
Recommended for
By recording guides, engineers and mic makers, for this mic or an earlier version of it.
Other mics
More from Audio-Technica
- Audio-Technica AT4050
- Audio-Technica AT2020
- Audio-Technica AT4047/SV
- Audio-Technica AT4033/CL
- Audio-Technica AT2035
- Audio-Technica AT4021
- Audio-Technica AT4040
- Audio-Technica AT4041