Mic Archive

DPA Microphones

DPA 4018A

Supercardioid small-diaphragm pencil condenser (d:dicate 4018A, 19 mm capsule with -20 dB attenuator)

Approximate Some readings for this mic are uncertain; see the graphs.

Power P48 (phantom power).

Type
Condenser
Pattern
Supercardioid
Sensitivity
−38.4 dBV/Pa
vs 75 end-address condensers

More output than 41% of 75 end-address condensers.

Each stripe is one end-address condenser with a published sensitivity, and each bar counts them; further right means more output. This mic is in blue.

  • Among 204 condensers: more output than 44%
  • Among 311 mics: more output than 61%
Self-noise
16 dB(A)
vs 104 end-address condensers

Quieter than 48% of 104 end-address condensers.

Each stripe is one end-address condenser with a published self-noise, and each bar counts them; further right means quieter. This mic is in blue.

  • Among 258 condensers: quieter than 45%
  • Among 272 mics: quieter than 46%
Max SPL
134 dB SPL
vs 110 end-address condensers

Takes louder sound than 27% of 110 end-address condensers.

Each stripe is one end-address condenser with a published max SPL, and each bar counts them; further right means it takes louder sound. This mic is in blue.

  • Among 277 condensers: takes louder sound than 33%
  • Among 343 mics: takes louder sound than 30%
Rated range
20 – 20k Hz

Frequency response

Angle

Distance

From the spec sheet d, p. 3.

Polar pattern

Transparency

From the spec sheet d, p. 4. Approximate

All specs

From the spec sheet d
Capsule19 mm pre-polarised condenser, pressure gradientCapsule and microphone diameter 19 mm (0.75 in); principle and cartridge on p. 1.p. 2
Sensitivity−38.4 dBV/Pa (12 mV/Pa)1 kHz, nominal ±2 dB. "12 mV/Pa; -38.4 dB re. 1 V/Pa".
Self-noise16 dB(A)typical (max. 19)
Self-noiseCCIR 46823 dBITU-R BS.468-4, typical (max. 26)
Max SPL134 dB SPLTHD < 1%, RMS (137 dB peak); also 156 dB SPL, THD 10%, peak. The 4018F gooseneck version (4018F sheet p. 2) gives 142 dB peak at 10% THD.
Dynamic range121 dBtypical
Output impedance200 ohmrated; also 100 ohm, 4018F gooseneck version
Rated load impedance2000 ohmminimum
Rated frequency range20 Hz to 20 kHzEffective range ±2 dB at 30 cm: 40 Hz - 18 kHz (p. 2).p. 1
PoweringP48 (phantom power)"Power supply (for full performance)".p. 2
Current draw2.8 mAalso 3.5 mA, 4018F gooseneck version
Pad0 / -20 dB switchable attenuator
ConnectorXLR-3M (pin 1 shield, pin 2 signal + phase, pin 3 - phase)
Weight158 g"158 g (5.6 oz)".
Dimensions170 × 19 mmMicrophone length 170 mm (6.7 in), diameter 19 mm (0.75 in).
FinishMatte black
Cable drive capability100 m (328 ft)
Output balance principleImpedance balancing with Active Drive
CMRR> 60 dB
Maximum output voltage, RMS8 Vp. 3
Polarity+V at pin 2 for positive sound pressure
Temperature range-40 °C to 45 °C
Relative humidityUp to 90%
Matching tolerancefrequency response and sensitivity±1 dB; phase deviation for a kit < 10°
From the spec sheet f
4018F gooseneck version100 Ω, 142 dB peak (10% THD), 3.5 mA, CMRR > 40 dB, max. output 2.2 V; capsule 23 mm long on 20 to 122 cm boom polesp. 2

Documents

Copies kept by Mic Archive (manufacturers move and drop their documents). Each is © DPA Microphones, unchanged, with its original address.

Other mics

More from DPA

All 19 DPA mics

Other supercardioid condenser mics

All 419 mics