Mic Archive
Electro-Voice RE90H
Photo: Electro-Voice, from its spec sheet, p. 1.

Electro-Voice

Electro-Voice RE90H

Back-electret condenser, cardioid, miniature hanging choir mic on 7.6 m of cable with an in-line electronics module (RE90 series); RE90HW is the white version

Power Phantom, 9-52 V DC.

Type
Condenser (electret)
Pattern
Cardioid
Sensitivity
−34 dBV/Pa
vs 75 end-address condensers

More output than 66% of 75 end-address condensers.

Each stripe is one end-address condenser with a published sensitivity, and each bar counts them; further right means more output. This mic is in blue.

  • Among 204 condensers: more output than 69%
  • Among 311 mics: more output than 79%
Self-noise
25 dB(A)
vs 104 end-address condensers

Quieter than 5% of 104 end-address condensers.

Each stripe is one end-address condenser with a published self-noise, and each bar counts them; further right means quieter. This mic is in blue.

  • Among 258 condensers: quieter than 10%
  • Among 272 mics: quieter than 10%
Max SPL
120 dB SPL
vs 110 end-address condensers

Takes louder sound than 0% of 110 end-address condensers.

Each stripe is one end-address condenser with a published max SPL, and each bar counts them; further right means it takes louder sound. This mic is in blue.

  • Among 277 condensers: takes louder sound than 3%
  • Among 343 mics: takes louder sound than 3%
Rated range
75 – 15k Hz

Frequency response

Angle

Distance

From the spec sheet, p. 2.

Polar pattern

Transparency

From the spec sheet, p. 2.

All specs

From the spec sheet
Sensitivity−34 dBV/Pa (20 mV/Pa)open circuit, 1 kHz. "20mV/Pascal"; converted (20 log10 0.020 = -34.0).p. 1
Self-noise25 dB(A)"Equivalent Noise: 25dB SPL “A” weighted".
Max SPL120 dB SPL1% THD (clipping level). "Clipping Level (1% THD): 120dB SPL".
Dynamic range95 dB
Output impedance200 ohm1 kHz, balanced, at the electronics module. "Output Impedance, 1 kHz: 200 Ohms".
Rated frequency range75 Hz to 15 kHz"75Hz to 15,000Hz (see chart)"; no tolerance stated.
Poweringphantom, 9-52 V DC"Power Requirements: Phantom, 9–52VDC".
Current draw5 mAless than, with a P48 supply; also 2 mA, 2006 sheet (rev D). "Current Consumption: <5 mA with P48 supply"; the 2006 sheet says "2.0 mA".
ConnectorXLR-3 male, on the electronics module"Three-pin male XLR-type output connector fits with female bulkhead XLR-type connector".
Weight157 gnet
Dimensions36.8 × 12.7 mmTransducer: length 36.8 mm, diameter 12.7 mm. Electronics module: length 94 mm, diameter 19 mm.
Finishlow-gloss black (RE90H) or low-gloss white (RE90HW)
Supplied accessoriessteel wire hanger and holding nutDescription: "the supplied steel wire hanger and holding nut".
Electronics moduleMetal cylinder, 94 mm long, 19 mm diameter
Cable7.6 m (25 ft), 2.6 mm diameter, braided and shielded, matching the mic colour; holds the mic's position (not rotation)
RF shieldingEV "RF Shield" against RFI/GSM; shielded pre-amp
Rear rejectionA&ETypically 15 dB below the front at 1.0 kHzp. 2
PolarityPin 2 positive, referenced to pin 3, with positive pressure on the diaphragmp. 1
Environmental conditions-29 to 74 °C at 0-50% relative humidity; -29 to 57 °C at 0-95%
Shipping weight324 g (11.4 oz)
Part numberF.01U.179.711 (data sheet); 534912 on the 2006 sheetp. 2
PlacementEV0.6-0.9 m (2-3 ft) in front of the first row and 0.6-0.9 m above the heads of the last row, aimed at the last row; 3-to-1 rule for several mics
From the spec sheet (Recording Hacks copy)
Power level-30.4 dB (0 dB = 1 mW/Pascal), 1 kHzp. 1

Documents

Copies kept by Mic Archive (manufacturers move and drop their documents), unchanged, with their original addresses. Each is © its publisher.

Other mics

More from Electro-Voice

All 23 Electro-Voice mics

Other cardioid condenser mics

All 419 mics