Mic Archive
Audio-Technica AT2050
Photo: Audio-Technica, from its spec sheet, p. 1.

Audio-Technica

Audio-Technica AT2050

Large-diaphragm condenser, multi-pattern (cardioid, omni, figure-8), with 10 dB pad and 80 Hz roll-off

Power Phantom 11-52 V DC.

Type
Condenser
Pattern
Switchable, 3CardioidOmniFigure-8
Sensitivity
−42 dBV/Pa
vs 75 side-address condensers

More output than 5% of 75 side-address condensers.

Each stripe is one side-address condenser with a published sensitivity, and each bar counts them; further right means more output. This mic is in blue.

  • Among 204 condensers: more output than 25%
  • Among 311 mics: more output than 47%
Self-noise
17 dB(A)
vs 99 side-address condensers

Quieter than 20% of 99 side-address condensers.

Each stripe is one side-address condenser with a published self-noise, and each bar counts them; further right means quieter. This mic is in blue.

  • Among 258 condensers: quieter than 40%
  • Among 272 mics: quieter than 41%
Max SPL
149 dB SPL
vs 107 side-address condensers

Takes louder sound than 92% of 107 side-address condensers.

Each stripe is one side-address condenser with a published max SPL, and each bar counts them; further right means it takes louder sound. This mic is in blue.

  • Among 277 condensers: takes louder sound than 90%
  • Among 343 mics: takes louder sound than 89%
Rated range
20 – 20k Hz
Released
2008

Frequency response

Angle

Distance

From the spec sheet, p. 2.

Polar pattern

Transparency

From the spec sheet, p. 2.

All specs

From the spec sheet
Capsuledual large diaphragms, gold-vaporized and aged"Dual large diaphragms are gold-vaporized and aged"; "Dual-diaphragm capsule design".p. 1
Sensitivity−42 dBV/Pa (7.9 mV/Pa)open circuit, 1 kHz. "–42 dB (7.9 mV), re 1V at 1 Pa". Not given per pattern.p. 2
Self-noise17 dB(A)typical, A-weighted (Audio Precision System One). "17 dB SPL", footnote 1.
Max SPL149 dB SPL1 kHz, 1% THD; also 159 dB SPL, with 10 dB pad (nominal)
Signal-to-noise ratio77 dB1 kHz at 1 Pa, typical, A-weighted
Dynamic range132 dB1 kHz at max SPL, typical
Output impedance120 ohm"120 ohms"; "low impedance balanced (120 ohms)" on p. 1.
Rated frequency range20 Hz to 20 kHzThe same for each pattern, as printed above each graph.
Poweringphantom 11-52 V DC
Current draw4.7 mAtypical
Low cutoff, 80 Hz, 12 dB/octave; 80 Hz; 12 dB/octave"80 Hz, 12 dB/octave"; switch "Flat, roll-off".
Pad−10 dB"10 dB pad (nominal)".
ConnectorXLR-3 male (integral)"Integral 3-pin XLRM-type".
Weight412 g"412 g (14.5 oz)".
Dimensions52 × 170 mmMaximum body diameter × length.
Supplied accessoriesAT8458 shock mount for 5/8"-27 threaded stands; 5/8"-27 to 3/8"-16 threaded adapter; soft protective pouch
Case styleR5
SwitchesPolar selection; flat, roll-off; 10 dB pad (nominal)
Output phasePin 2 hot: positive acoustic pressure gives positive voltage at pin 2p. 1
Operating temperatureAvoid temperatures above 110° F (43° C) for long periods, and very high humidity
From the Recording Hacks page
Released2008

Documents

Copies kept by Mic Archive (manufacturers move and drop their documents), unchanged, with their original addresses. Each is © its publisher.

Other mics

More from Audio-Technica

All 32 Audio-Technica mics

Other cardioid / omni / figure-8 condenser mics

All 419 mics